Changing Model Materials Without Flushing - Stratasys J4100 User Manual

Stratasys J4100 User Guide
14. In the final wizard screen, click Done.
15. Inspect the area around the purge unit and clean it, if necessary.
Empty material containers can be used as printer-waste containers.
Before printing models, you need to run the Head Optimization wizard in
these cases:
• after changing the printing mode
• after replacing Vero with Digital ABS or Agilus30 Model materials (and the
reverse)
• after replacing the Support material with cleaning fluid (and the reverse)
See "Optimizing (Calibrating) Print Heads" on page 4-56

Changing Model Materials Without Flushing

If you do not change the printing mode (High Speed / Super High Speed) you
can replace the Model materials without flushing out the current materials. Use
this option when the color or mechanical properties of the printed model are
unimportant.
To change Model materials without flushing:
1. In the Material Replacement Options screen, click Advanced Settings.
2. In the Advanced Settings screen, select Manual slot selection and click
DOC-26000 Rev. C
The printer-control application is automatically updated, and it restarts.
When it opens, the interface displays the new material(s).
The interface in the job preparation application is also updated, and it
displays the new material(s).
Apply.
Figure 4-17 Manual slot selection
4 Operating and Maintaining the Printer
4-20