Table of Contents
Advertisement
Stratasys J4100 User Guide
To clean the printer components:
1. Prepare—
2. Start the Cleaning wizard from the Options menu.
3. Make sure that the build tray is in the printer, and close the printer doors.
DOC-26000 Rev. C
❒ 90% isopropanol (IPA—isopropyl alcohol) or ethanol (ethyl alcohol)
❒ disposable cleaning gloves
❒ a supplied 3M sanding sponge
❒ a supplied cleaning cloth or equivalent
❒ a mirror
Figure 4-39 Options > Wizards menu
Confirm this in the wizard screen and click Next.
Figure 4-40 Preparation check
After you indicate whether or not the build tray is clear, the printer moves
components to the cleaning position. If there are models on the tray, it moves
down to prevent damage to the models and the print block.
4 Operating and Maintaining the Printer
4-38
Advertisement
Table of Contents
