Table of Contents
Advertisement
Stratasys J4100 User Guide
4. Using a 2-mm hex (Allen) key, remove the screws to remove the splash
Warning: Hot Surface
The print head orifice plates (bottom surface) may be hot. Do not touch them
with your bare hands, and proceed with caution.
5. Soak a cleaning cloth with 90% alcohol and clean the splash shield.
6. Return the splash shield to the print block and secure it with four (4) screws.
After cleaning the print heads and the splash shield, continue with step 9 in
the daily cleaning routine (see "Cleaning the Print Heads, UV Lamp Glass,
Roller and Wiper" on page 4-40).
DOC-26000 Rev. C
shield.
Figure 4-68 Print-head splash shield installed on the print block
Figure 4-69 Removing the print-head splash shield
4 Operating and Maintaining the Printer
4-55
Advertisement
Table of Contents
