Stratasys J4100 User Manual page 38

Stratasys J4100 User Guide
7. If, for any reason, the correct number does not appear in the dialog box, enter
You cannot continue printing the model if:
• The number of the last slice printed does not appear in the printer interface,
• There was a relatively long interruption in printing, even if the "last slice" and
DOC-26000 Rev. C
Figure 4-11 Printer interface after interrupted printing
the number and click OK.
even if the server computer displays the confirmation dialog box.
indicators are correct. This is because the part already printed might slightly
deform or shrink before printing continues, causing a visible difference
between it and the part of the model printed later. The effects of a printing
stoppage depend on the model size and structure, the Model material used,
ambient temperature and the length of the stoppage.
4 Operating and Maintaining the Printer
4-13