Stratasys J4100 User Manual page 78

Stratasys J4100 User Guide
13. In the following screen, you can choose to either repeat the head alignment
DOC-26000 Rev. C
procedure, or close the wizard.
Figure 4-66 Repeat head alignment option
❒ If the most closely aligned vertical lines for a print head were at either
extreme, choose Repeat the test, then click Next.
The additional transparency test will show if the heads are now properly
aligned, and—if not—the wizard will allow you to "fine tune" the
alignment.
❒ If the vertical lines for the print heads were not aligned at either extreme,
choose End this wizard, then click Next.
4 Operating and Maintaining the Printer
4-53