Stratasys J4100 User Manual page 69

Stratasys J4100 User Guide
5. Detach the UV bracket from the print block.
6. Loosen the two screws securing the suction tube on the print block.
7. Lift the suction tube to secure it in a raised position.
DOC-26000 Rev. C
a. Loosen screws A, B and C.
b. Remove screws D and E.
Figure 4-47 UV bracket attached to the print block
c. Slide the bracket upward, to separate it from the print block.
Figure 4-48 UV bracket detached from the print block
Figure 4-49 Lifting the suction tube
4 Operating and Maintaining the Printer
4-44