Changing Model Materials Without Flushing - Stratasys J850 User Manual

Stratasys J850/J835 User Guide
Before printing, you need to run the Head Optimization wizard in these
cases:
• after replacing Vero with Digital ABS or Agilus30 model materials (and the
reverse)
• after changing the type of Support material (SUP705/706)
• after replacing the Support material with cleaning fluid (and the reverse)
See "Optimizing (Calibrating) Print Heads" on page 4-64

Changing Model Materials Without Flushing

If you do not change the printing mode (High Quality/Speed) you can replace
the model materials without flushing out the current materials. Use this option
when the color or mechanical properties of the 3D print are unimportant.
To change model materials without flushing:
1. In the Material Replacement Options screen, click Advanced Settings.
2. In the Advanced Settings screen, select Manual slot selection and click
DOC-18001 Rev. H
Apply.
Figure 4-28 Manual slot selection
4 Operating and Maintaining the Printer
4-26