Stratasys J4100 User Manual page 77

Stratasys J4100 User Guide
10. In the head-alignment screen, select the number that indicates which lines
11. Click Next to display the next head alignment screen, and again select the
12. Continue as follows:
DOC-26000 Rev. C
align in the upper and lower rows of a pair on the transparency (counting from
the left) for this print head.
Note: Because the alignment of the fourth lines is optimum, the number "4"
is selected, by default, in the wizard screen. This does not change the head
alignment. If you select other numbers, the wizard adjusts the head
alignment, accordingly.
number representing the most closely aligned vertical lines on the
transparency for that print head.
When you have finished aligning all of the heads, the following screen is
displayed.
Figure 4-65 Parameter update confirmation
❒ To make the alignment changes in the printer, make sure that Update
system with new parameters is selected, and click Next.
❒ To recheck the alignment test results before making the alignment
changes in the printer, click Previous.
❒ If you do not want to make alignment changes in the printer at this time,
select Keep previous parameters, and click Next.
4 Operating and Maintaining the Printer
4-52