Table of Contents
Advertisement
Stratasys J4100 User Guide
Changing the Printing Material
Before producing models using a different type of printing material than is
currently installed, run the Material Replacement wizard to flush the print block
and feed tubes.
After changing Support material with the wizard, Head Optimization is
required before printing models.
You should carefully plan printing models with different materials to avoid
unnecessary waste of the materials currently loaded.
Note: When performing manual material replacement, certain replacement
options are blocked to protect the system. In these cases, follow the
recommendations of the Material Replacement wizard for best replacement
options.
To replace the printing material with the wizard:
1. Start the Material Replacement wizard from the Options menu.
2. In the opening screen, click Next.
3. If the printer doors are not closed, a screen appears, prompting you to close
DOC-26000 Rev. C
Figure 4-12 Starting the Material Replacement wizard
them. Confirm this and click Next.
4 Operating and Maintaining the Printer
4-15
Advertisement
Table of Contents
