Table of Contents
Advertisement
Stratasys J4100 User Guide
3. Position the UV sensor box in the lower-right corner of the build tray.
4. Confirm the items listed in the wizard screen and click Next.
Continue with "UV Measurement " on page 4-80.
External UV Meter
The following steps apply when using a stand-alone UV meter. This section does
not apply when using the Stratasys UV sensor box connected to the printer.
1. When the following screen appears, open the printer and place the UV
DOC-26000 Rev. C
Figure 4-109 Sensor positioning
sensor (probe) at the rear edge of the tray, in the center.
Figure 4-110 Sensor placement screen
4 Operating and Maintaining the Printer
4-78
Advertisement
Table of Contents
