Stratasys J4100 User Manual page 31

Stratasys J4100 User Guide
4. Attach the material feed tube to the container.
When preparing a new feed tube, make sure that the air hole in the cap is
open.
5. Check the printer interface to make sure that the new container is detected
6. Close the storage-compartment door.
Tips about loading and replacing material containers:
You can replace material containers either before or during printing.
l
You can load partially used containers, provided that they contain more than
l
100 grams of material.
You can replace a partially used container to avoid the need for replacing it
l
during printing.
The container type is automatically detected by the printer. If you replace a
l
container with one that has different Model material, a message appears
recommending that you run the Material Replacement wizard to flush out the
old material.
If printing stops for an extended time before you replace a material container,
l
the printer may go into Standby or Idle mode. If this happens, see "Resuming
Production After Printing has Stopped" on page 4-11.
DOC-26000 Rev. C
Figure 4-5 Material container cap
You should hear a clicking sound when the connector is securely attached to
the container. Make sure that the connector is secure.
and that its weight is displayed (see the figure on page 4-4).
4 Operating and Maintaining the Printer
4-6