Stratasys J4100 User Manual page 44

Stratasys J4100 User Guide
10. Click Next to begin the material replacement process in the printer.
Symbols:
11. Replace material containers as necessary, according to the instructions in the
Make sure to securely attach the cap to partially used material containers
when not loaded in the printer. If not properly capped, exposure to UV light
could cause polymerization (curing) of the material, making it unsuitable for
printing.
12. Click Start.
13. Read the warning message, and click OK.
If you continue, you must complete the material replacement process before
you can produce models. To replace material containers at another time, click
Cancel. If you continue (by clicking OK) and you do not complete the process,
you will need to run the wizard again before producing models.
DOC-26000 Rev. C
The positioning screen appears, showing you the new location of the
containers in the materials compartments.
Figure 4-16 Container placement
The correct container is in this position.
No container (or the incorrect container) is in this position.
The container in this position has insufficient weight to complete the material
replacement process.
The expiration date of the container in this position has passed.
wizard screen.
4 Operating and Maintaining the Printer
4-19