Producing Models; Preparing The Printer - Stratasys J4100 User Manual

Stratasys J4100 User Guide

Producing Models

Models can be printed after they are arranged on a virtual build tray in the
GrabCAD Print application. For information about preparing model files for
printing, see the GrabCAD Print

Preparing the Printer

Before beginning to produce models, it is recommended that you check the
current printing quality of the print heads by performing the Pattern Test.
To prepare the printer for producing models:
1. Make sure that the build tray in the printer is empty and clean. If not, remove
Caution
Use protective gloves when cleaning the build tray, and be careful of the
sharp edges of the scraper blade.
2. Check that the print heads and roller assembly are clean. If not, clean them
3. Make sure that there is sufficient Model and Support material loaded, as
For installing material containers and replacing empty ones, see "Loading
Model and Support Containers" on page 4-5.
For changing the type of material currently loaded, see "Changing the Printing
Material" on page 4-15.
DOC-26000 Rev. C
cured material with the scraper, and clean the tray thoroughly with a cleaning
cloth soaked with 90% alcohol (IPA or ethanol).
The build tray for the J4100 printer is removable, which aids in the removal
and handling of printed models. Make sure that the build tray is installed when
preparing the printer for producing models.
before printing, especially if the print job is longer than 100 hours.
indicated on the printer interface (see the figure on page 4-4). You may want
to replace the containers of Model and Support material currently loaded in
the printer to avoid the need for replacing them during printing.
Note: When you click Print in GrabCAD Print, a warning message appears if
there is not enough of one or more material.
4 Operating and Maintaining the Printer
online documentation.
4-7