Stratasys J4100 User Manual page 75

Stratasys J4100 User Guide
3. When the following screen appears, place the transparency on the build
4. Make sure that the transparency sheet is lying flat, and tape it to the tray.
5. Close the printer cover.
6. In the wizard screen, select the check box to confirm that the transparency
7. Open the printer and remove the transparency.
DOC-26000 Rev. C
tray—next to the left and rear edges of the tray (see below).
Figure 4-59 Transparency confirmation
Figure 4-60 Positioning the transparency on the build tray
sheet is secured to the build tray, and click Next.
When you click Next, the printer prints the head alignment test on the
transparency. When printing is finished, the following screen appears.
Figure 4-61 Head Alignment wizard—steps
4 Operating and Maintaining the Printer
7–9
4-50