Table of Contents
Advertisement
Stratasys J4100 User Guide
25. In the next wizard screen, confirm that you have removed all tools and objects
26. Close the printer doors.
27. After replacing print heads, you should run the wizard again, to optimize the
Installation Problems
If the printer detects that there is a problem after you install print heads, a
relevant warning screen appears.
➢ If the printer software does not detect the replaced head, release the print
DOC-26000 Rev. C
from the printer.
Figure 4-101 Cleared-tray confirmation screen
The wizard continues by heating the heads, then filling and purging them.
If installation problems are detected, the wizard alerts you and instructs you
how to continue (see "Installation Problems" below).
new heads, and to make sure that they are optimized for printing with the
other heads. In the final wizard screen, select Optimize all print heads and
click Next.
Figure 4-102 Final wizard Screen
head card and re-insert it. (see "Removing the Defective Head" on page 4-
67).
4 Operating and Maintaining the Printer
4-73
Advertisement
Table of Contents
