Table of Contents
Advertisement
Stratasys J4100 User Guide
Removing Models After Printing
After printing models, you should allow them to cool as much as possible before
handling them. If additional models do not have to be produced on the printer, it is
best to let the printed models cool in the printer, with the cover closed, as long as
possible.
Removing the Build Tray From the Printer
The build tray for the Stratasys J4100 printer is removable, which aids in the
handling of printed models. You use a special cart to remove the build tray and
transfer it to the cleaning station.
To remove the build tray:
1. Press F10.
2. Raise the cart's platform and position the docking guides as shown.
DOC-26000 Rev. C
or—
From the Options menu, select Go to Tray Lower Position.
The print block moves forward and the build tray lowers.
Figure 5-1 Positioning the cart for tray removal
Note: Make sure that the anchor on the platform is raised above the docking
pin on the printer.
5 Handling Printed Models
5-2
Advertisement
Table of Contents
