Conveyor Technology Control Parameters - Siemens SINAMICS G115D Operating Instructions Manual

Advanced commissioning
6.9 Conveyor technology control functions (for G115D PROFINET and AS-i variants only)
Parameters
6.9.5

Conveyor technology control parameters

Parameter
r0722.0...25
p1070[0...n]
p1071[0...n]
p1075[0...n]
p1076[0...n]
206
Conveyor technology control parameters (Page 206)
Description
CO/BO: Digital inputs
status
CI: Main setpoint
CI: Main setpoint scal-
ing
CI: Supplementary
setpoint
CI: Supplementary
setpoint scaling
Setting
Interconnect the signals of the sensors to the digital inputs as desired.
Sets the signal source for the main setpoint.
Sets the signal source for scaling the main setpoint.
Factory setting: 1
Sets the signal source for the supplementary setpoint. Note that the
supplementary setpoint adds to both p3397 and p3398
Sets the signal source for scaling the supplementary setpoint.
Factory setting: 1
Operating Instructions, 12/2020, FW V4.7 SP13, A5E48681219B-002
SINAMICS G115D distributed drive