Siemens SINAMICS G115D Operating Instructions Manual page 308

Distributed drive for conveyor technology control

Hide thumbs Also See for SINAMICS G115D:

Table of Contents

Data backup and series commissioning

7.1 Transferring settings using a memory card

Inserting a memory card

You may find the memory card slot on the G115D Wiring Module. See the following images

for the detailed location:

SINAMICS G115D converter with SIMOGEAR geared motor

SINAMICS G115D wall-mounted converter

For more information about performing a converter firmware upgrade and downgrade by

using a memory card, see the following chapter:

Further information

Using memory cards from other manufacturers

If you do not use a recommended SD memory card, you must format it as follows:

• Insert the card into your PC's card reader.

• Command to format the card:

format x: /fs:fat or format x: /fs:fat32 (x: Drive code of the memory card on your PC.)

Firmware upgrade and downgrade (Page 351)

Operating Instructions, 12/2020, FW V4.7 SP13, A5E48681219B-002

SINAMICS G115D distributed drive