Dut Test Module For Si/Sic D; Pak 7-Pin Devices - Keysight PD1500A Installation And Use Manual

Double-Pulse Test System Si/SiC Test Fixture
Installation and Use Guide
4 DUT Test Module for Si/SiC
2
D

PAK 7-pin Devices

In this Chapter:
General Information
2
D PAK Devices page 53
Install Two Transistors on the Module
Install Device Heater and Thermocouple on SMD Device
55
Install Chip Devices on the Module
Always use Anti-static procedures when soldering the DUTS to
the modules and installing the Test Modules into the Test Fixture.
See "Static-safe Handling Procedures" on page 16.
Heater temperatures between 150 ° C and 175 ° C are valid only for
TO-247 device packages. Do not use temperatures above 150 °C
2
for D PAK devices.
These Keysight printed circuit assemblies (PCAs) are RoHS
compliant. You must use a lead-free soldering process when
2
soldering the D PAK devices to the PC board.
For detailed information on soldering devices to the printed circuit
assembly, refer to the latest IPC 610 standard.
page 52
page 53
page 56
page
51