D 2 Pak Devices; Typical 7-Pin Dpak Smd Device; Install Two Transistors On The Module - Keysight PD1500A Installation And Use Manual

2
D PAK Devices
2
D PAK Devices
Typical 7-Pin D
Figure 20 Typical 7-pin D

Install Two Transistors on the Module

You must install two identical devices on the DUT Module. They must be of the
same type but do not need to be matched devices.
DUTS must be soldered to PCB. Refer to "Install Device Heater and
Thermocouple on SMD Device" on page 55 for detailed information.
Keysight Double-Pulse Test Fixture Installation and Use Guide
2
PAK SMD Device
Drain
(Tab)
Pin 2 is the Kelvin Source pin, also known as the Drive Source pin.
Avoid bending any of the pins on the DUT or the DUT Test
Module. Carefully align all of the pins with the connector before
installing the PCB.
DUT Test Module for Si/SiC D
Source
(Pins 3-7)
Kelvin Source
(Pin 2)
Gate (Pin 1)
2
PAK (TO-263-7) Power Device
Gate
(pin 1)
Kelvin or
Driver Source
(pins 2)
2
PAK 7-pin Devices
9.7 mm
1 mm
9.0 mm
Drain
(tab)
Power Source
(pins 3-7)
53