Cleaning The Protection Probe - Keysight PD1500A Installation And Use Manual

Double-Pulse Test Preparation

Cleaning the Protection Probe

If the probe requires cleaning:
1 Disconnect the probe from the oscilloscope, external power supply, and any
2 Gently clean the probe with a soft cloth dampened with a mild soap and water
3 Wipe with clean water to remove detergent, dry thoroughly with a clean cloth.
4 Ensure the probe is completely dry before reconnecting it to an oscilloscope.
42
Before using the PD1000-60002 Protection Probes, refer to
"Oscilloscope Probe Safety Information"
probes with care and refer to the safety notices in this manual.
Avoid any mechanical shocks to these probes to guarantee
accurate performance and protection.
Use of the PD1000-60002 Protection Probe:
- The Protection Probe requires Infiniium Oscilloscope Software
for Windows 10, version 06.40 (or later) in the DSOS104
Oscilloscope. You can download and install the latest version
of firmware from: www.keysight.com\find\DSOS104A. Select
Drivers, Firmware & Software, then Instrument Firmware/Software.
- Use only with a Keysight S-Series oscilloscope.
- Autoprobe I interface – provides probe power, probe offset, and
auto configuration of probe type and attenuation settings.
- Operates into input of oscilloscope being set to 1MΩ.
- DC input impedance: 50 Ω.
- Bandwidth > 500 MHz.
- 2:1 divider ratio.
- No compensation.
- Protection circuit is powered from +12VF and -12 VF. Maximum
current is limited to 20 mA.
Must be Grounded. Before making connections to the input
leads of this probe, ensure that the probe's output
connector is attached to the channel input of the
oscilloscope and the oscilloscope is properly grounded.
circuit under test.
solution.
Coaxial Shunt Resistor and PD1000-60002 Protection Probe
Keysight Double-Pulse Test Fixture Installation and Use Guide
on page ix. Handle the