Keysight PD1500A Installation And Use Manual page 8

Do not use this system in any manner not specified by the manufacturer. The
protective features of this system may be impaired if it is used in a manner not
specified in the operation instructions. This system is an INDOOR USE product only.
This system complies with INSTALLATION CATEGORY II for mains input and
INSTALLATION CATEGORY I for measurement input terminals, and POLLUTION
DEGREE 2 defined in IEC 61010-1.
If an system is marked CAT I (IEC Measurement Category I), or it is not marked with a
measurement category, its measurement terminals must not be connected to line-
voltage mains.
Safety of any system incorporating the equipment is the responsibility of the
assembler of the system.
DANGEROUS PROCEDURE WARNINGS
• Warnings shall be complied. Procedures throughout in this manual prevent you from potential
hazardous situations. The instructions contained in the warnings must be followed.
BEFORE APPLYING POWER
• Verify that all safety precautions are taken. Make all connections to the system before applying
power. Note the system's external markings described under "Safety and Regulatory Symbols".
GROUND THE RACK
• This is Safety Class I system. To minimize shock hazard, the Rack and Safety Enclosure must be
connected to an electrical ground. The power terminal and the power cable must meet
International Electrotechnical Commission (IEC) safety standards.
DO NOT OPERATE IN AN EXPLOSIVE ATMOSPHERE
• Do not operate the system in the presence of flammable gases or fumes. Operation of any
electrical instrument in such an environment constitutes a definite safety hazard.
DO NOT REMOVE COVERS
• No operator serviceable parts inside. Refer servicing to qualified personnel. To prevent
electrical shock do not remove covers.
IN CASE OF DAMAGE
• Instruments, probes or cables that appear damaged or defective should be made inoperative
and secured against unintended operation until they can be repaired by qualified service
personnel. Return the product to a Keysight Technologies sales or service office for service and
repair to ensure that safety features are maintained.
USE ONLY THE SPECIFIC ACCESSORIES
• Specified accessories satisfy the requirements for specific characteristics for using the
instruments and the Rack and Safety Enclosure.
CLEANING
• Disconnect the power from the rack before cleaning the Rack and Safety Enclosure. Use only a
damp cloth to clean the surfaces of the Rack and Safety Enclosure.
viii