Install Two Transistors On The To-247-3 And -4 Dut Modules - Keysight PD1500A Installation And Use Manual

Install Two Transistors on the TO-247-3 and -4 DUT Modules

Install Two Transistors on the TO-247-3 and -4 DUT Modules
You must install two identical devices on the DUT Module. They do not need to
be matched devices.Insert DUT transistors before installing the Module on the
Test Fixture.
Coaxial
Shunt
Resistor
Header Pins
for High-Side
Gate Drive
Module
Install identical
device here. This
is the High-Side
device.
Bend the Kelvin
Source pin out
slightly to fit the
sockets.
Figure 16
TO-247-3 (top) and TO-247-4 (bottom) Device DUT Modules for Si/Sic Devices
Keysight Double-Pulse Test Fixture Installation and Use Guide
Install Device Heater and Thermocouple on Device
Install identical device here.
This is the High-Side device
DUT Test Module for Si/SiC T0-247-3 and -4 Devices
Install Device to be tested (DUT)
here. This is the Low-Side device
10076A High Voltage
Oscilloscope Probe
Socket
Header Pins for
Low-Side Gate
Drive Module
Header Pins for
Clamp Circuit
Module
Install Device to be
tested (DUT) here. This is
the Low-Side device.
Bend the Kelvin Source
(KS) pin out slightly to fit
the sockets.
45