Table of Contents
Advertisement
Safety Warnings
The following warnings and cautions are applicable to the Double-Pulse Test Rack and Safety
Enclosure. Observe all safety precautions and warnings.
Grounding
This product has not been evaluated for connection to an IT power system, an AC distribution system
having no direct connection to earth (ground), according to EN60950.
Leakage Current
Power Limitations
Accessories
Intended Use of Equipment
The Keysight Double-Pulse Test Rack and Safety Enclosure and Test Fixtures, along with the
recommended accessories, are intended to be used for the PD1500A Dynamic Power Device
Analyzer/Double-Pulse Tester.
vi
This is a safety class I product and has a protective earthing
(grounding) terminal. There must be an un-interruptible safety
earth ground from the main power source to the product's input
wiring terminals, power cord, or supplied cord set. Whenever it is
likely that the protection has been impaired, disconnect the power
cord until the ground has been restored.
Due to the instruments installed in this cabinet, there is a risk of
leakage current (> 3.5 mA). Reliable ground circuit continuity is
required for safe operation of this product. To reduce the risk of
electrical shock, an earth (ground) connection is essential before
connecting the AC power mains. Never operate the system with the
ground connector disconnected. Use a permanent safety ground
connection (described in PD1500A System Installation Guide
Chapter 1) or a plug meeting the IEC 60309 (CEE plug) requirements.
To reduce the risk of overload, do not load any single PDU with more
than a maximum of 16 Amperes. In addition, do not load a single
NEMA 5-15 or IEC-320 receptacle with more than 15 Amperes.
This product is designed for use with specific electrical accessories
(i.e., PDUs, fans, oscilloscope & probes, high voltage cables, etc.).
The use of any other accessory is not recommended or supported.
Advertisement
Table of Contents
