Install Chip Devices On The Module - Keysight PD1500A Installation And Use Manual

DUT Test Module for Si/SiC D

Install Chip Devices on the Module

Chip devices may be installed on the D2PAK DUT modules. Figure 24 shows the
maximum dimensions for the chip device. Refer to Figure 20 on page 53 for
device pin-out.
11 mm wide
Figure 24 Installing Chip Devices on the D2PAK Test Module
56
2
PAK 7-pin Devices
The back-side of the chip device (the Drain) must be soldered to
the DUT module.
6 mm gap
6 mm gap
Install Chip Devices on the Module
Keysight Double-Pulse Test Fixture Installation and Use Guide
Pad area
for chip
11 mm