Pd1000A Test Fixture For The Pd1500A Double-Pulse Test System; Connections On Back Of Test Fixture - Keysight PD1500A Installation And Use Manual

PD1000A Test Fixture for the PD1500A Double-Pulse Test System

PD1000A Test Fixture for the PD1500A Double-Pulse Test System
Figure 1 below shows the PD1000-68701 Test Fixture. This test fixture is for Si
and SiC devices only. It is not for GaN devices.
Heater Light turns on
when Heater/DUT
temperature exceeds
approximately 50 °C.
Second thermocouple
jack (not used)
Connect
Waveform
Generator Cables
here
Probe Deskew
Connectors
Figure 1 PD1000-68701 Test Fixture for Si/SiC devices

Connections on Back of Test Fixture

BNC from 33512B
Waveform
Generator Ext. Trig
High Voltage
Banana
Jacks from
Safety Box
(under work
surface)
Connector
reserved for
future use. Do
not attempt
to connect
anything here.
Figure 2 Back of PD1500A Si/SiC Test Fixture Indicating Cable Installation
Keysight Double-Pulse Test Fixture Installation and Use Guide
USB port
Ethernet from
LAN Switch (not used)
50 Pin Connector from
Safety Box (under Work
Surface)
General Information
Heater
thermocouple jack
Heater power jack
DPT Test
Modules area
Power Connector
from 48V Power
Supply
17