Table of Contents
Advertisement
Connect Oscilloscope Probes to Oscilloscope
Figure 13 Connecting Oscilloscope Probes to the Test Modules (Clamp Circuit Module not shown)
Keysight Double-Pulse Test Fixture Installation and Use Guide
IMPORTANT: When installing the N2819A Differential oscilloscope
probe on the I
pins on the Low Side Gate Driver Module, the
G
Probe Compensation Adjustment hole must face outward. The
Keysight logo must face toward the module. Verify with the +/-
symbols on the module and on the probe body.
If you use the Clamp Circuit Module, do not install the N2819A
Differential Probe. Instead, install one N2873A 10:1 Oscilloscope
Probe connected to the Clamp Test Module (V
Double-Pulse Test Preparation
Probe
Compensation
Adjustment
Hole
Note the +/-
symbols.
) probe socket.
CLAMP
N2819A Differential
Probe (see Caution
above)
Standard N2873A
Probe
High Voltage 10076C
Probe
K-Thermocouple
Connector
Device Heater Jack
Coaxial Shunt with
PD1000-60002
Protection Probe
cable
39
Advertisement
Table of Contents
