Table of Contents
Advertisement
Install Device Heater and Thermocouple on SMD Device
Install Device Heater and Thermocouple on SMD Device
After soldering the SMD device to the DUT Test Module, use the SMD Device
Clamp to secure the heater and integrated thermocouple to the SMD device.
Figure 23 Install the Clamp and Device Heater on an SMD Device
- Insert the clamp screws up through from the bottom of the PC board and into
- Use a Torx T8 screw driver on clamp screws
- Tighten only enough to hold the DUT and heater assembly together. Do not
Keysight Double-Pulse Test Fixture Installation and Use Guide
SMD Device
Insert screws up through the circuit board into the clamp
the clamp. Note that only one-half of the clamp is used.
over tighten.
DUT Test Module for Si/SiC D
Clamp
Circuit Board
2
PAK 7-pin Devices
55
Advertisement
Table of Contents
