Kenwood NX-1200 Series Function Reference page 99

4 NXDN function
Scan Function (Revert Channel Display)
Type
Description
Operating the transceiver
Note
Configuration using FPU
Scan Function (Scan LED)
Type
Description
Operating the transceiver
Note
Configuration using FPU
Scan Function (Scan Stop Tone)
Type
Description
Operating the transceiver
Note
Configuration using FPU
'■ Standard model □ Basic model
If Revert Channel Display is enabled, Revert Channel is displayed.
Display during single scan (Revert Channel
Display = Disable)
Display during single scan (Revert Channel
Display = Enable)
The following setting items are FPU setting items.
 If Revert Channel Display is enabled, a Revert Channel always appears on the transceiver display during the
scan.
Revert Channel Display : Edit > Scan Information > Scan
'■ Standard model ■ Basic model
If Scan LED is enabled, the LED flashes while the transceiver is scanning.
The following setting items are FPU setting items.
Configuration
Off The LED does not flash.
Yellow The LED flashes yellow.
Purple The LED flashes purple.
Blue The LED flashes blue.
Light Blue The LED flashes light blue.
Red The LED flashes red.
Green The LED flashes green.
White The LED flashes white.
-
-
Scan LED : Edit > Scan Information > Scan
'■ Standard model ■ Basic model
Scan Stop Tone is the function to emit the Scan Stop Tone (1 beep) from the transceiver if the scan pauses and
cannot not resume, for example, while the transceiver migrates to a Home Channel or Direct Channel.
The transceiver pauses scanning if the conditions to start the scan are not satisfied, such as while the
transceiver is migrating to a Home Channel or Direct Channel, and then a Scan Stop Tone (1 beep) sounds from
the transceiver at 30-sec intervals.
-
 The Scan Stop Tone (1 beep) does not sound while the transceiver is transmitting or while the speaker is
unmuted for reception.
Scan Stop Tone : Edit > Scan Information > Scan
 Press PF_BTN[Scan].
Transceiver behavior :
 Tone A sounds and scan is started.
 Scan icon
is displayed.
 "SCAN" is displayed on the main text.
 The items displayed on the icon area depend on the Revert
Channel.
 The LED blinks according to the Scan LED setting.
 Press PF_BTN[Scan].
Transceiver behavior :
 Tone A sounds and scan is started.
 Scan icon
is displayed.
 Revert Channel is displayed.
 The LED blinks according to the Scan LED setting.
Scan LED
Description
-
-
99