Advertisement
3 DMR function
Copying the Configuration Data to Another Transceiver (Clone Mode)
Type
Description
Operating the transceiver
Note
Configuration using FPU
Changing the Configuration of the Transceiver (Front Panel Programming Mode)
Type
Description
Operating the transceiver
Note
Configuration using FPU
'■ Standard model
■ Basic model
Clone Mode can be used to copy the data configured for the transceiver to another transceiver.
The following data cannot be copied in Clone Mode:
・Tuning Data
・Embedded Message with Password
・KENWOOD ESN Data
・Model Name
・Backup Data
If the data is copied to a transceiver having a different firmware version number, this may result in an error or a
failure of the transceiver to function correctly. In such a case, the cloned transceiver operation must be verified
prior to using this transceiver on a regular basis.
Refer to the service manual for instructions on how to operate the transceiver in Clone Mode, and for details
on the Clone function.
Clone ： Edit > Optional Features > Optional Features 1 > Common 2 > Mode
'■ Standard model
□ Basic model
This mode can be used to change data, such as the frequency on a Conventional Channel, and to add a
Conventional Channel in the transceiver only.
Even if no KPG-D6/ D6N and PC is available, required data can be configured by using only the transceiver.
Press [<B]
Pressing the PTT Switch and [Side 1] button places the transceiver in Front Panel Programming Mode.
Refer to the service manual for instructions on how to operate the transceiver in Front Panel Programming
Mode.
Front Panel Programming : Edit > Optional Features > Optional Features 1 > Common 2 > Mode
Turn the transceiver ON while pressing and holding the
[ Side 2] button.
Transceiver behavior :
The transceiver enters Clone Mode.
Press the PTT switch.
Transceiver behavior :
Tone A sounds from the transceiver and copying the data
starts.
The LED lights red.
Transceiver behavior :
Copy the data.
Copying the data ends.
The LED is turned off.
Transceiver behavior :
Press and hold [PTT]+[Side 1] during power on the
transceiver will enter into Front Panel Programming mode
with display of "PANEL PG".
Press [S] to next stage.
Transceiver behavior :
Zone-Channel Selection stage.
"ZONE XXX" will be displayed to indicate zone number going
to be configured in next stage where XXX is the zone number.
15
Advertisement
