Advertisement
4 NXDN function
Testing or Adjusting the Transmit and Receive Capabilities of the Transceiver (PC Tuning Mode)
Type
Description
Operating the transceiver
Note
Configuration using FPU
Unmuting the Speaker (Audio Control)
Type
Description
Operating the transceiver
Note
Configuration using FPU
'■ Standard model
■ Basic model
PC Tuning Mode can be used to adjust transmit and receive capabilities of the transceiver by using KPG-D6/
D6N.
To test or adjust the transceiver in each mode, the transceiver and a PC with KPG-D6/ D6N installed need to be
connected by using the programming cable.
Refer to the service manual for operating the transceiver in PC Tuning Mode, and instructions on how to
adjust transmit and receive capabilities.
-
'■ Standard model
■ Basic model
Audio Control is the condition which allows the transceiver to unmute the speaker by a RAN code and an
Optional Signaling.
Using KPG-D6/ D6N, the condition which allows the transceiver to unmute the speaker can be configured for
each system.
The transceiver unmutes the speaker and emits received audio if the conditions configured for Audio Control
are satisfied.
Conditions to unmute the speaker can be changed by a combination of the RAN code and the Optional
Signaling.
Configuration
RAN
The transceiver unmutes the speaker if the received RAN code matches the RAN
code preconfigured for the transceiver. Conditions remain unchanged even if the
transceiver transmits.
RAN and Optional
While the received RAN code matches the RAN code preconfigured for the
Signaling
transceiver, the transceiver unmutes the speaker if Optional Signaling matches
the Optional Signaling preconfigured for the transceiver. Conditions remain
unchanged even if the transceiver transmits.
-
The transceiver behaves as follows according to the type of a received signal on a channel with "Mixed"
configured in Channel Type.
If the transceiver receives analog signals:
The transceiver behaves according to the configuration in Audio Control (Analog).
If the transceiver receives NXDN digital signals:
The transceiver behaves according to the configuration in Audio Control (NXDN).
Audio Control : Edit > Zone Information > Channel Edit > NXDN
Select a tuning item from the list of tuning items.
Transceiver behavior :
Tuning Mode is entered.
Audio Control
Description
-
67
Advertisement
