Advertisement
3 DMR function
Sending and Receiving a Status Message (Status Call)
Type
Description
Operating the transceiver
Note
Configuration using FPU
'■ Standard model
'■ Basic model
Status Call is a simple messaging system that allows a user to send and receive a status (Status Message).
Since the message is replaced by status, communications can take place quickly and communication traffic can
be reduced.
Enter Status Mode (Standard Model Only)
Send Status Message
Press the PF_BTN[Call 1] to PF_BTN[Call 6]
-
Status Message Stack :
Edit > Optional Features > Optional Features 1 > Common 4 > Stack Condition
Emergency Status Response :
Edit > DMR > General
Emergency Alarm Response (LCD, Alert Tone) :
Edit > DMR > General > Emergency Alarm Response
PF_BTN[Call 1~6]
Edit > Button Assignment > Side, Front
Call 1 to Call 6 :
Edit > Button Assignment
Press PF_BTN[Status] to send Status to the Base ID.
Press PF_BTN[Individual + Status] to select Unit ID or
Manual input. Then, press [S] to send Status with Individual
Call.
Press PF_BTN[Group + Status] to select Group ID. Then,
press [S] to send Status with Conventional Group Call.
Transceiver behavior :
The Status List is displayed when Status Mode is entered
Press [<B]/[C>].
Transceiver behavior :
The Status is decremented/incremented.
Select the Status List or enter manually the status.
Press [PTT] or [Side 2].
Transceiver behavior :
"SEND DAT" will be displayed when Status Message is start
sending.
When the TX LED is set, the red LED will light up during
transmission.
Transceiver behavior :
Complete Tone is played and "COMPLETE" indication is
displayed for 1 second when ACK is received. Then,
transmission is completed.
Transmission is completed without receiving an ACK for
cases other than Individual Call,
Set "DMR (Status)" to Call 1 to Call 6 by KPG-D6/D6N and
PF_BTN[Call 1] to PF_BTN[Call 6] is pressed to Active. Sends
the selected Status Message.
30
Advertisement
