Advertisement
4 NXDN function
Other Functions in Emergency Mode (Emergency Channel Lock)
Type
Description
Operating the transceiver
Note
Configuration using FPU
Zone-channel Functioning in Emergency Mode (Emergency Channel Type)
Type
Description
Operating the transceiver
Note
Configuration using FPU
Automatically Transmitting and Receiving in Emergency Mode (Emergency Cycle)
Type
Description
Operating the transceiver
Note
Configuration using FPU
'■ Standard model
■ Basic model
Emergency Channel Lock is the function to disable changing a zone or channel while the transceiver is in
Emergency Mode.
If this function is enabled, a zone or channel cannot be changed while the transceiver is in Emergency Mode.
If this function is disabled, a zone or channel can be changed while the transceiver in Emergency Mode is not
transmitting.
-
-
Emergency Channel Lock : Edit > Emergency Information > General
'■ Standard model
■ Basic model
Emergency Channel Type is the type of a channel used when the transceiver is placed in Emergency Mode.
Configuration
Selected Channel
When the transceiver enters Emergency Mode, the transceiver resets the
migration state of channels, such as Home Channel, and then the transceiver
executes Emergency on the previously selected channel.
Preset Channel
After entering Emergency Mode, the transceiver migrates to the Zone-channel
configured in Emergency Zone-Channel and then executes the Emergency
behavior.
-
If "Preset Channel" is configured in Emergency Channel Type, a channel with "Site Roaming" or "Site
Roaming with RAN" configured cannot be configured in Emergency Zone-channel.
Emergency Channel Type : Edit > Emergency Information > Profiles > Page 2 > Emergency Channel
'■ Standard model
■ Basic model
Emergency Cycle is the number of times that the transceiver toggles between transmission and reception for
an emergency in Emergency Mode.
Configuration
1 to 200
The transceiver repeats automatic transmission and automatic reception for the
configured number of times, and then the transceiver exits Emergency Mode.
Infinite
The transceiver continues to alternate between automatic transmission and
reception until the Emergency button is pressed again or the transceiver is
turned OFF.
Off
The transceiver does not automatically transmit and receive in Emergency Mode.
-
Automatically Transmitting and Receiving in Emergency Mode The number of times for which the transceiver
toggles between transmission and reception, or the duration for a single session of automatic transmission or
reception for emergency in Emergency Mode can be configured. Also, the microphone sensitivity can be
changed and the Background Tone (1 beep) can be multiplexed on the audio to be transmitted in Emergency
Mode.
・ Emergency Cycle
・ Locator Tone at TX-start
・ Locator Tone at TX-end
・ Transmit Duration
・ Receive Duration
・ Emergency Microphone Sense
・ Background Tone Transmission
Emergency Cycle : Edit > Emergency Information > Profiles > Page 2 > Option
-
Emergency Channel Type
Description
-
Emergency Cycle
Description
-
86
Advertisement
