Advertisement
5 ANALOG function
Transparent Function
Type
Description
Operating the transceiver
Note
Configuration using FPU
'■ Standard model
■ Basic model
Transparent is the function that allows data communications using the FleetSync protocol. This function can be
used by connecting a PC, card reader or telemetry devices to the transceiver. Using this function, the transceiver
can send or receive data without limiting the data type. This function can be used without operating the
transceiver. All operations are controlled by data from other devices.
Using this function, a PC connected to the receiving transceiver can decode the transmitted bar-code data, for
instance, while the bar-code reader is connected to a PC on the transmitting transceiver to transmit the bar-code
data.
Data communications using Transparent can be used to send or receive the ASCII characters of 0x00 to 0xFF
without any restriction.
In addition, data communications using Transparent supports baud rates of 1200 bps, 2400 bps, 4800 bps, 9600
bps and 19200 bps.
-
To use this function, "Transparent" must be assigned to the communication port connecting the transceiver
and an external device by using KPG-D6/ D6N.
Data Preamble Extension Time : Edit > FleetSync > Parameter
Function, Stop Bit, Baud Rate : Edit > External Device
Transparent Header : Edit > External Device > Serial Output
Transparent on Data Zone-Channel : Edit > FleetSync > Parameter
-
118
Advertisement
