Advertisement
4 NXDN function
Password When Reading Configuration Data in a PC (Password (Read))
Type
Description
Operating the transceiver
Note
Configuration using FPU
Password for Writing Configuration Data (Password (Write))
Type
Description
Operating the transceiver
Note
Configuration using FPU
'■ Standard model
■ Basic model
Password (Read) is the function to protect the configuration data, such as the operating frequencies, from
being read by unauthorized persons if the transceiver should ever be stolen.
To read data using KPG-D6/ D6N from the transceiver with Password (Read) configured, a password needs to
be entered on a PC.
The configuration data in the transceiver cannot be read unless the correct password is entered.
Password (Read) can be configured for the transceiver using KPG-D6/ D6N.
A password can be arbitrarily configured using a maximum of 16 alphanumeric characters.
If the password authentication fails consecutively for the number of times configured in Password Entry Limit,
the transceiver enters Transceiver Lockout Mode, and then "LOCKOUT" appears on the display. Also, for
Basic Model, the LED lights switching between red and light blue.
In Transceiver Lockout Mode, the transceiver cannot be operated. Writing configuration data to the transceiver
by using KPG-D6/ D6N, the transceiver exits Transceiver Lockout Mode.
Also, a failure in Password (Write) authentication counts as a failure in the password authentication. The number
of failures in the password authentication is cleared by one of the following conditions:
・ When the transceiver is turned OFF and then turned ON again
・ When the correct password is entered
・ When configuration data is written to the transceiver by using KPG-D6/ D6N
-
-
Password :
Edit > Optional Features > Optional Features 1 > Common 1 > Data Password > Read
Password Entry Limit :
Edit > Optional Features > Optional Features 1 > Common 1 > Data Password
'■ Standard model
■ Basic model
Password (Write) is the function to protect the configuration data from being overwritten by unauthorized
persons if the transceiver should ever be stolen.
To write data using KPG-D6/ D6N to the transceiver with Password (Write) configured, a password needs to be
entered on a PC.
Password (Write) can be configured for the transceiver using KPG-D6/ D6N.
A password can be arbitrarily configured using a maximum of 16 alphanumeric characters.
-
-
Password, Confirmation :
Edit > Optional Features > Optional Features 1 > Common 1 > Data Password > Write
Password Entry Limit :
Edit > Optional Features > Optional Features 1 > Common 1 > Data Password
-
-
64
Advertisement
