Advertisement
4 NXDN function
Using NXDN ID to Initiate a Selective Call (Paging Call)
Type
Description
Operating the transceiver
Note
Configuration using FPU
Sending the Received Unit ID from the Communication Port (Serial Output)
Type
Description
Operating the transceiver
Note
Configuration using FPU
'■ Standard model
■ Basic model
Paging Call is the function to initiate a call to a target party.
Use it when you want to call a target transceiver without communicating.
Paging Call from Individual Call Mode
(Standard model Only)
Press the PF_BTN[Call 1] to PF_BTN[Call 6]
-
PF_BTN[Call 1~6]
Edit > Button Assignment > Side, Front
'■ Standard model
■ Basic model
Serial Output allows the transceiver to send the received Unit ID etc. from its communication port when the
transceiver receives the PTT ID etc...
Unit ID (Serial Output) allows the transceiver to send the received Unit ID from its communication port when
the transceiver receives the PTT ID.
Transparent Header (Serial Output) is the function to send the KENWOOD proprietary sentence to an
application which is used during data communications using Transparent.
The Header is sent for data sent first. Transparent Data is sent after sending the Header.
The application software may be able to recognize from where the data is sent by analyzing this Header
information.
COM Port 0
The transceiver can make data communications if "Data", "GPS", "Transparent",
or "Transparent 2 (NXDN)" is assigned to its communication port.
Status Message (Serial Output) allows the transceiver to send the Status and the Unit ID of the transmitting
transceiver from its communication port when the transceiver receives a Status Message.
Short Message (Serial Output) allows the transceiver to send a Short Message and the Unit ID of the
transmitting transceiver from the transceiver's communication port when the transceiver receives a Short
Message.
-
-
Unit ID, Transparent Header, Status Message, Short Message :
Edit > External Device > Serial Output
COM port 0 :
Edit > External Device > COM port 0 > Function
Enter Individual Call Mode, select the ID from ID List or
manual input the ID that want to perform a paging call.
Press [Side 2].
Transceiver behavior :
"PAGING" displayed, and then Paging Call is transmitting to
the selected ID.
Transceiver behavior :
When ACK is received, "COMPLETE" is displayed, and
Complete Tone is sounded to complete Paging Call. After 1
second, it returns to channel display.
-
75
Advertisement
