Advertisement
3 DMR function
Initiating Voice Communications (Basic Transmission and Reception) (Auto Slot Select)
Type
Description
Operating the transceiver
Note
Configuration using FPU
Making an Individual Call (Individual Call)
Type
Description
Operating the transceiver
Note
Configuration using FPU
'■ Standard model
■ Basic model
Auto Slot Select is a function that automatically selects a slot or switches the slot according to the
communication status of the transceiver.
Allowing transceivers to make use of vacant slots helps to reduce communication traffic and achieve
communication with little delay.
Configuration
Auto
Auto Slot Select is enabled.
1 or 2
Auto Slot Select is disabled. Communicates only with the selected slot number.
-
Auto Slot Select runs only in the Repeater Mode. It does not function in the Direct Mode. Auto Slot Select
functions even when only the receive frequency is configured in the Repeater Mode.
Using Auto Slot Select allows communication to be carried out by two communication lines at a single
frequency.
Slot Selection : Edit > Zone Information > Channel Edit > DMR
'■ Standard model
■ Basic model
Individual Call can be used to initiate a call to a target transceiver individually to establish voice calls.
By specifying a Unit ID, the transceiver can initiate a call to the transceiver having the Unit ID.
Individual Call can be started by one of the following methods:
Individual Call Mode (Standard Model Only):
While the transceiver is in Individual Call Mode, the transceiver can initiate an Individual Call by a user selecting
a Group ID configured in the Group ID List and then pressing the PTT switch.
Individual Call from Selcall on PTT:
The transceiver initiates an Individual Call when the PTT switch is pressed on a channel where "Individual Call"
is configured for Call Type. The Group ID of the target transceiver can be configured by selecting one Group ID
from the Group ID List by using KPG-D6/ D6N.
Enter Individual Call Mode
(Standard Model Only)
Press PF_BTN[Individual]
Select an ID in Individual Call Mode
Individual Call from Selcall on PTT
-
ID, ID Name, Type, Alert Tone (Individual, Paging), Alert LED (Individual, Paging) :
Edit > DMR > Unit ID List
Call Type : Edit > Zone Information > Channel Edit > DMR > Selcall on PTT
Slot Selection Configuration (Auto Slot Select)
-
Press PF_BTN[Individual]/PF_BTN[Individual +
Status]/PF_BTN[Individual + Short Message].
Transceiver behavior :
The ID List is displayed when Individual Call Mode is entered.
The last called Unit ID is displayed.
Press [<B]/[ C>].
Transceiver behavior :
ID is decremented/incremented.
23
Description
Advertisement
