Advertisement
3 DMR function
Sending the Received Unit ID from the Communication Port (Serial Output)
Type
Description
Operating the transceiver
Note
Configuration using FPU
Initiating an Individual Call After Ensuring That the Target Party Is Available for Communications (Individual Call
Acknowledge Request)
Type
Description
Operating the transceiver
Note
Configuration using FPU
'■ Standard model
■ Basic model
Serial Output allows the transceiver to send the received Unit ID etc. from its communication port when the
transceiver receives the PTT ID etc...
Unit ID (Serial Output) allows the transceiver to send the received Unit ID from its communication port when
the transceiver receives the PTT ID.
Transparent Header (Serial Output) is the function to send the KENWOOD proprietary sentence to an
application which is used during data communications using Transparent.
The Header is sent for data sent first. Transparent Data is sent after sending the Header.
The application software may be able to recognize from where the data is sent by analyzing this Header
information.
COM Port 0
The transceiver can make data communications if "Data", "GPS", or "Transparent" is assigned to its
communication port.
Status Message (Serial Output) allows the transceiver to send the Status and the Unit ID of the transmitting
transceiver from its communication port when the transceiver receives a Status Message.
Short Message (Serial Output) allows the transceiver to send a Short Message and the Unit ID of the
transmitting transceiver from the transceiver's communication port when the transceiver receives a Short
Message.
-
-
Unit ID, Transparent Header, Status Message, Short Message :
Edit > External Device > Serial Output
COM port 0 :
Edit > External Device > COM port 0 > Function
'■ Standard model
■ Basic model
Individual Call Acknowledge Request is the function that allows a user to distinguish whether or not the
receiving transceiver is available to communicate so as to initiate an Individual Call in a DMR Conventional
system.
If Optional Signaling LED is enabled, yellow LED will blink.
Individual Call Acknowledge Request, Call Request Tone, Call in Progress Tone :
Edit > DMR > Conventional 3 > Individual Call Acknowledge Request
Call Processing Tone, Call Processing Tone Delay Time :
Edit > DMR > Conventional 3 > Individual Call Acknowledge Request > Call Processing Tone
Optional Signaling LED : Edit > DMR > Conventional 3
-
Select the ID to be called from the Unit ID List or Stack Mode.
Press [PTT] or [Side 2].
Transceiver behavior :
ACK Request message is sent to the selected ID.
At this time, "CALLING" are displayed.
Transceiver behavior :
When ACK is received from the called party, if Call in
Progress Tone is enabled, Call in Progress Tone will sound,
"CALLING" display will be cleared, and Individual Call
transmission will be possible.
When ACK is received while [PTT] is pressed, if PTT Proceed
Tone is enabled, PTT Proceed Tone will sound, and Individual
Call transmission is started.
25
Advertisement
