4 NXDN function
Copying the Configuration Data to Another Transceiver (Clone Mode)
Type
Description
Operating the transceiver
Note
Configuration using FPU
'■ Standard model
■ Basic model
Clone Mode can be used to copy the data configured for the transceiver to another transceiver.
The following data cannot be copied in Clone Mode:
・Tuning Data
・Embedded Message with Password
・KENWOOD ESN Data
・Model Name
・Backup Data
If the data is copied to a transceiver having a different firmware version number, this may result in an error or a
failure of the transceiver to function correctly. In such a case, the cloned transceiver operation must be verified
prior to using this transceiver on a regular basis.
Refer to the service manual for instructions on how to operate the transceiver in Clone Mode, and for details
on the Clone function.
Clone : Edit > Optional Features > Optional Features 1 > Common 2 > Mode
Turn the transceiver ON while pressing and holding the [Side
2] button.
Transceiver behavior :
The transceiver enters Clone Mode.
Press the PTT switch.
Transceiver behavior :
Tone A sounds from the transceiver and copying the data
starts.
The LED lights red.
Transceiver behavior :
Copy the data.
Copying the data ends.
The LED is turned off.
65