Kenwood NX-1200 Series Function Reference page 95

4 NXDN function
Using Scan (Scan)
Type
Description
Operating the transceiver
Note
Configuration using FPU
Using Scan (Scan Type)
Type
Description
Operating the transceiver
Note
Configuration using FPU
Scanning in One Zone (Single Scan)
Type
Description
Operating the transceiver
Note
Configuration using FPU
'■ Standard model ■ Basic model
Scan is the function to check whether the transceiver receives a call from other transceivers.
The transceiver sequentially searches for availability of signal on each channel, and the transceiver receives on
the channel where the signal is detected.
Two methods are available for Scan as shown below.
 Single Scan
The transceiver scans target channels in the same zone.
 Multi Scan
The transceiver scans all target channels in the target zones.
-
-
-
'■ Standard model ■ Basic model
If a scan starts in the zone where "Single" is configured in Scan Type, Single Scan is executed.
Or, if the transceiver migrates during the scan to the zone where "Single" is configured in Scan Type, Single
Scan is executed.
If a scan starts in the zone where "Multi-Zone" is configured in Scan Type, Multi Scan is executed.
Or, if the transceiver migrates during the scan to the zone where "Multi-Zone" is configured in Scan Type, Multi
Scan is executed.
-
-
Scan Type : Edit > Scan Information > Scan
'■ Standard model
■ Basic model
The transceiver scans using Single Scan all the added channels in the zone where the transceiver starts
scanning.
If a scan starts in the zone where "Single" is configured in Scan Type, Single Scan is executed.
Or, if the transceiver migrates during the scan to the zone where "Single" is configured in Scan Type, Single
Scan is executed.
Display during Scan Temporary Stop
Display during Scan Off
-
Scan Type, Selected Channel Scan, Revert Channel Display, Scan LED :
Edit > Scan Information > Scan
PF_BTN[Scan]
PF_BTN[Menu]
Edit > Button Assignment > Side, Front
Scan Add :
Edit > Zone Information > Channel Edit > General
-
-
Transceiver behavior :
 The
icon blinks while paused.
 The Scan LED is turned off.
 Press PF_BTN[Scan].
Transceiver behavior :
 Tone B sounds and scan is ended.
 Scan icon
is turned off.
 Selected channel is displayed.
 The Scan LED is turned off.
95