Advertisement
4 NXDN function
Changing the Configuration of the Transceiver (Front Panel Programming Mode)
Type
Description
Operating the transceiver
Note
Configuration using FPU
Checking the Firmware Version (Transceiver Information Mode) (Transceiver Information)
Type
Description
Operating the transceiver
Note
Configuration using FPU
Testing or Adjusting the Transmit and Receive Capabilities of the Transceiver (PC Test Mode)
Type
Description
Operating the transceiver
Note
Configuration using FPU
'■ Standard model
■ Basic model
This mode can be used to change data, such as the frequency on a Conventional Channel, and to add a
Conventional Channel in the transceiver only.
Even if no KPG-D6/ D6N and PC is available, required data can be configured by using only the transceiver.
Press [<B]
Pressing the PTT Switch and [Side 1] button places the transceiver in Front Panel Programming Mode.
Refer to the service manual for instructions on how to operate the transceiver in Front Panel Programming
Mode.
Front Panel Programming : Edit > Optional Features > Optional Features 1 > Common 2 > Mode
'■ Standard model
□ Basic model
Transceiver Information Mode is the function to display the version of the firmware written in the transceiver and
the corresponding checksum.
-
For Basic Model, Transceiver Information can be checked in the following FPU.
Transceiver Information : Tools > Transceiver Information
Transceiver Information : Edit > Optional Features > Optional Features 1 > Common 2 > Mode
'■ Standard model
■ Basic model
PC Test Mode can be used to test transmit and receive capabilities of the transceiver by using KPG-D6/ D6N.
To test or adjust the transceiver in each mode, the transceiver and a PC with KPG-D6/ D6N installed need to be
connected by using the programming cable.
Refer to the service manual for operating the transceiver in PC Test Mode, and instructions on how to adjust
transmit and receive capabilities.
-
Transceiver behavior :
Press and hold [PTT]+[Side 1] during power on the
transceiver will enter into Front Panel Programming mode
with display of "PANEL PG".
Press [S] to next stage.
Transceiver behavior :
Zone-Channel Selection stage.
"ZONE XXX" will be display to indicate zone number going to
be configure in next stage where XXX is the zone number.
-
Enter Test Mode using the FPU.
Transceiver behavior :
Test Mode is entered.
66
Advertisement
