Advertisement
4 NXDN function
Using the GPS Function (GPS Function)
Type
Description
Operating the transceiver
Note
Configuration using FPU
Transmission Method of GPS Data (NXDN - GPS Base Station)
Type
Description
Operating the transceiver
Note
Configuration using FPU
Transmission Method of GPS Data (NXDN - GPS Combination)
Type
Description
Operating the transceiver
Note
Configuration using FPU
'■ Standard model
■ Basic model
Global Positioning System (GPS) is the system to acquire the current location information of the own transceiver
by receiving signals from the Global Positioning System satellites orbiting the earth.
The transceiver of the mobile station can send the acquired own location information (GPS data) to the base
station. The base station can send received GPS data to the PC as serial commands.
GPS Data transmission
GPS data transmission completed
-
GPS Report Mode, Number of Times, GPS Report Interval Time, GPS Time Mark, GPS Message Type,
GPS Distance Change, Respond to Polling ID, GPS Report on Data Zone Channel :
Edit > Optional Features > Optional Features 2 > GPS
'■ Standard model
■ Basic model
ID (GPS > Base Station) is the ID of the target transceiver used for sending GPS data.
By using KPG-D6/ D6N, either Unit ID or Group ID can be configured as ID (GPS > Base Station). The ID of the
base station which is responsible for operation and administration of system is normally configured.
-
If ID (GPS > Base Station) is not configured, GPS data is sent to the Base ID to which data such as a Status
Message and Short Message is to be sent.
ID Type, ID :
Edit > NXDN > GPS > Base Station
Base ID : Edit > NXDN > General 1
'■ Standard model
■ Basic model
The transceiver can send GPS data by adding the GPS data to a Status Message using NXDN.
To use this function, Status for GPS Combination must be enabled by using KPG-D6/ D6N. The range of
status numbers (Combination Status Range) to which GPS data can be added can be configured.
-
The transceiver can send GPS data by adding the GPS data to a signal while making voice calls.
To use this function, Voice Call for GPS Combination must be enabled by using KPG-D6/ D6N.
The GPS data added to a Status Message is sent to the ID configured for Base ID (GPS) or Base ID.
Voice Call, Status, Combination Status Range, Emergency :
Edit > NXDN > GPS > GPS Combination
Transceiver behavior :
When GPS Report Interval Time expired, or when receiving a
GPS Data transmission request, it sends GPS Data.
"SEND DAT" is displayed during GPS data transmission.
When "COMPLETE" is displayed 1 second when GPS data
transmission is completed.
The Transmit LED lights up while sending GPS data.
-
-
83
Advertisement
