Advertisement
4 NXDN function
Multi-key List
Type
Description
Operating the transceiver
Note
Configuration using FPU
Using Communication Security (Unencrypted Call Alert Tone)
Type
Description
Operating the transceiver
Note
Configuration using FPU
'■ Standard model
■ Basic model
Multi-key List is the list to configure the encryption key data used for the encryption and decryption of
communication data.
A maximum of 16 entries of encryption key data can be configured in the Multi-key List by using KPG-D6/ D6N.
However, only one of the encryption key data can be used for transmission.
Configuration
Type
For NXDN, Multi-key List can be configured only in the Bit scrambler.
Key Data
In Key Data, the encryption key data in the range between 1 and 32767 can be
configured.
Key ID
Key ID is an ID code to identify the encryption key data. Key ID can be
configured in the range between 0 and 63.
Key Name
In Key Name, a name corresponding to the encryption key data can be
configured by using a maximum of 8 alphanumeric characters and symbols.
These can be configured for each channel as Number on Multi-key List.
-
-
Type, Key Data, Key ID, Key Name :
Edit > Encryption
Encryption, Number on Multi-key List :
Edit > Zone Information > Channel Edit > NXDN > Encryption
'■ Standard model
■ Basic model
Unencrypted Call Alert Tone is the function used to notify a user with a short beep that the communication
data is not encrypted when the transceiver starts transmitting without communication data being encrypted.
-
If both Unencrypted Call Alert Tone and PTT Proceed Tone are enabled, a Proceed Tone (3 beeps) sounds
from the transceiver after an Unencrypted Call Alert Tone (1 beep) sounds.
If both Unencrypted Call Alert Tone and VOX Proceed Tone are enabled, a Proceed Tone (1 beep) sounds
from the transceiver after an Unencrypted Call Alert Tone (1 beep) sounds.
Unencrypted Call Alert Tone : Edit > Encryption
Encryption Configuration of Multi-Key List
Description
-
-
94
Advertisement
