Advertisement
3 DMR function
Sending and Receiving a Status Message (Status Call) (Status List)
Type
Description
Operating the transceiver
Note
Configuration using FPU
Transceiver Behavior When the Transceiver Receives an Emergency Status (Emergency Status (DMR))
Type
Description
Operating the transceiver
Note
Configuration using FPU
'■ Standard model
■ Basic model
To use a Status Message, the status to be sent must be preconfigured in the transceiver by using KPG-D6/ D6N
prior to the transmission. A maximum of 1024 statuses can be configured in the Status List.
Configuration
Status
The status number can be configured.
It can be configured in the range from 0 to 1023.
Status Name
The status number can be configured. It is not easy to recognize the meaning of a
status only by viewing a status number. In this case, a user can link the status
number to a short message; hence, it can be easily understood. A maximum of 8
characters can be configured.
If the status number is configured in the Status List, the Status Name appears when
the transceiver receives a Status Message. If the transceiver receives a status that
is not configured in the Status List, the status number appears on the transceiver
display.
Transmit Inhibit
The permission or inhibition of transmission of status can be configured.
Status for which Transmit Inhibit has been enabled does not appear on the Status
selection display in Status Mode.
In this case, a user cannot select status for which Transmit Inhibit has been
enabled, in Status Mode.
Alert Tone
The type of tone sounding from the transceiver can be configured for a received
status number from the status numbers registered in the Status List.
-
-
Status, Status Name, Transmit Inhibit, Alert Tone :
Edit > DMR > Status List
'■ Standard model
■ Basic model
The following status IDs that are sent when automatic transmission in Emergency Mode is started can be
configured for each factor that activates Emergency Mode (Emergency Button, Lone Worker, Man-down,
Stationary, or Motion):
The corresponding fixed text string appears if the received status ID matches the status ID configured in below.
Configuration
Emergency Call Status
The status ID that is sent when the transceiver enters Emergency Mode by
pressing the Emergency button
Lone Worker Status
The status ID that is sent when the transceiver enters Emergency Mode by the
Lone Worker function
Man-down Status
The status ID that is sent when the transceiver enters Emergency Mode by the
Man-down function
Stationary Status
The status ID that is sent when the transceiver enters Emergency Mode by the
Stationary function
Motion Status
The status ID that is sent when the transceiver enters Emergency Mode by the
Motion function
-
For a DMR Conventional system, to send each of the above status IDs when the automatic transmission in
Emergency Mode starts, Emergency Status (DMR) needs to be enabled.
Emergency Status (DMR) ： Edit > Emergency Information > General
Status List
Description
-
Emergency Status (DMR)
Description
-
31
Advertisement
