Fujitsu Airstage J-II Series Design & Technical Manual page 754

13) Press the "
of (2). If setting has been completed, press the FAN " " button to return to the Menu 2-F1
item selection screen.
NOTE:
● This item cannot be set from slave remote controllers.
„ FUNCTION DETAILS
„
Refer to 2-8. FUNCTION DETAILS.
„ COMPLETION OF FUNCTION SETTING MODE
„
15) Press and hold the FAN " " button for at least 2 seconds to return to the Menu 1 item
selection screen. Then, press and hold the SET TEMP. " " and FAN " " button for at least
2 seconds at the same time to return to the "Monitor Mode" screen.
„ SETTING UP EACH INDOOR UNIT
„
Indoor unit
01
Simple remote
controller
Repeat the procedures in steps 1) through 8), and set up the indoor units
requiring function setting.
„ RESET THE POWER AFTER SETTING UP FUNCTION OF ALL
„
INDOOR UNITS
Important
¾ If the reset is not performed, function cannot be read in normally.
„
¾ After all the functions have been set, the circuit breaker needs to be switched off
„
for at least 2 minutes.
After the 2 minutes has passed, power can be restored.
¾ The set function is stored in the PCB and will remain in memory even when the
„
power is turned off.
However setting function is effective after power reset.
Record the function set in the indoor unit on a label, etc., and affix the label to the
unit so it can be used for after-sales service operations.
" button to return to the 2-wire remote controller address selection screen
Indoor unit Indoor unit
00 0 01 01 1 01 02
- (07 - 107) -
Indoor unit
2 01 13 0
Simple remote Simple remote
controller controller
Indoor unit Indoor unit
01 14 1 01 15 0