Fujitsu Airstage J-II Series Design & Technical Manual page 676

„ PREPARATION
„
3) Turn on the power to the indoor unit.
● By turning on the power indoor units initializes EEV, so make sure the piping air-tight test and
vacuuming have been conducted before turning on the power.
● Also check again to make sure no wiring mistakes were made before turning on the power.
Breaker ON
„ SWITCHING SELECTION OF ADDRESS SETTING MODE
„
4) When the [Function Setting] on the "Maintenance" screen is touched, the "Installer
Password Verification" screen is displayed.
Enter the Installer Password, and touch the [OK]. "Function Setting" screen is displayed.
Maintenance
Test Run
I.U. Address
Function Setting
Setting
Previous
Back
Page
Page 2/ 3
R.C. Address
Setting
Next
Page
- (07 - 29) -
Indoor
units
Function Setting
Address [002–01]
Function No.
Setting No.
Back Setting
Address setting mode initial display
Indoor
units
[00]
[00]