Fujitsu Airstage J-II Series Design & Technical Manual page 433

„ FUNCTIONS
„
3
4
7
Display panel
8
9
12
*1 : "AUTO " is not available for a heat pump model unless it is set up as an administrative indoor
unit.
*2 : "FAN " is not available for a heat pump model.
*3 : "HEAT " is not available for a cooling only model.
*4 : During address display mode.
*5 : For single split system, to use this function, set the Function setting of the indoor unit accordingly.
2
6
1
5
11
10
13
- (05 - 70) -
1 START/STOP button
Pressed to start and stop operation.
2 LED lamp
Lights during operation.
3 Operation mode button
Selects the operating mode
4 Set temperature button
Selects the setting temperature.(18-30°C[COOL], 10-30°C[HEAT])
5 Fan control button
Selects the fan speed
6 Louver button
Set the airflow direction.
7 Room temperature sensor(inside)
8 Operating mode indicator
9 Set temperature
Indicates Indoor unit address. *4
10 Fan speed indicator
(AUTO
QUIET
11 Airflow direction indicator
12 Status icons
Mode mismatch
Filter sign *5
Defrost operation
Oil recovery operation
Under maintenance
Error
Special state
Conducting electricity
Emergency stop
Operation controlled
Forced stop
Remote controller sensor is enabled *5
Central controlled
Setting temperature range is enabled
Operation prohibited
13 Indicates the remote controller address. *4
(AUTO * 1, COOL , DRY
*3) .
FAN *2, HEAT
, HIGH , MED , LOW
).
,
,