Fujitsu Airstage J-II Series Design & Technical Manual page 706

„ FUNCTION SETTING
„
1) After verifying that the system is operating normally, press the MODE/EXIT button (SW107)
once.
LED105 LED104
2) Press the SELECT button (SW108), and display "F2" on the LED104.
(Monitoring mode)
LED105 LED104
*1
(The display of the LED104 changes each time when the SELECT button is pressed.)
*1:The "F1"and "F9" modes are used for maintenance, so do not set them in regular operation.
3) When "F2" appears on the LED104, press the ENTER button (SW109).
A flashing display appears on the LED105, and the flashing display of "F2" on the LED104
changes to the illuminated display of a number.
LED105 LED104
4) Referring to the Settings List shown below, press the SELECT button (SW108) and display the
code number of the mode you want to set on the LED105.
Ex.) To select switching between Forced Stop and Emergency Stop
LED105 LED104
Next, press the ENTER button (SW109), and confirm the selection of the mode you want to
set.
LED105 LED104
A flashing display on the LED105 changes to an illuminated display, and an illuminated display
on the LED104 changes to a flashing display.
LED105 LED104
(Setting mode)
LED105 LED104
LED105 LED104
LED105 LED104
LED105 LED104
- (07 - 59) -
(Function mode)
LED105 LED104
(Error history mode)
LED105 LED104
*1