Fujitsu Airstage J-II Series Design & Technical Manual page 760

Function
Function
number
00
*1 Auto
40
restart
01
00
Cool Air
43
Prevention
01
00
01
External
46
control
02
00
Error
report 47
01
target
00
Fan setting
49
when cooling
thermostat OFF
01
00
01
02
*2 Switching
03
functions
for external
60 04
inputs and
external outputs 05
terminals
06
07
08
00
01
02
Control
switching of 61
external heaters
03 *3
04 *3
00
01
Operating
02
temperature
62
switching of
03
external heaters
04
05
*1 : Auto restart is an emergency function such as for power failure etc.
Do not start and stop the indoor unit by this function in normal operation.
Be sure to operate by the control unit, converter or external input device.
*2 : Inappropriate setting may cause an external device malfunction. Confirm whether all the settings have been
performed appropriately according to the installing condition.
*3 : Only VR-II is setable.
Setting number Default
Enable
Disable
Super low
Follow the setting
on the remote
controller
Start/Stop
Emergency stop
Forced stop
All
Display only on
central remote
control
Follow the setting
on the remote
controller
Stop
Mode 0
Mode 1
Mode 2
Mode 3
Mode 4
Mode 5
Mode 6
Mode 7
Mode 8
Auxiliary heater
control 1
Auxiliary heater
control 2
Heat pump
prohibition control
Heater selection
control using
external
temperature 1
Heater selection
control using
external
temperature 2
Setting 0
Setting 1
Setting 2
Setting 3
Setting 4
Setting 5
- (07 - 113) -
Enable or disable automatic system restart after a power outage.
Restrain the cold airflow with making the airflow lower when starting
heating operation. To correspond to the ventilation, set to 01.
Allow an external controller to start or stop the system, or to perform
an emergency stop, or to perform a forced stop.
* If an emergency stop is performed from an external controller, same
refrigerant system will be disabled.
* If forced stop is set,indoor unit stops by the input to the external input
terminals,and Start/Stop by a remote controller is restricted.
Change the target for reporting errors. Errors can either be reported in
all locations, or only on the wired remote.
When set 00, Indoor unit is continued operation based upon Central
remote controller or individual controller set.
Once indoor unit received signal from External controller, Indoor unit
changed Fan mode forcibly.
When set 01, Indoor unit is continued operation based upon Central
remote controller or individual controller set.
Once indoor unit received signal from External controller, Indoor unit
stop forcibly.
Connection of the wired remote controller
(2-wire type or 3-wire type) and switching its thermistor are necessary.
Set this function when connected to external devices such as the VRF
system ventilator, economizer, humidifier, etc.
The connection terminal functions can be changed depending on
the type of external device. For details of the connection terminal
functions, refer to Chapter 8. 1-2. INDOOR UNIT.
Sets the control method for the external heater being used. For details
of the control method, refer Chapter 8. 1-2-2. EXTERNAL OUTPUT.
Sets the temperature conditions when the external heater is ON.
For the temperature conditions, see "Temperature conditions when the
external heater is ON".
Details