Fujitsu Airstage J-II Series Design & Technical Manual page 442

„ FUNCTIONS
„
3
6
Display panel
7
8
11
*1 : "AUTO " is not available for a heat pump model unless it is set up as an administrative indoor unit.
*2 : "FAN " is not available for a heat pump model.
*3 : "HEAT " is not available for a cooling only model.
*4 : During address display mode.
*5 : For single split system, to use this function, set the Function setting of the indoor unit accordingly.
2
5
1
4
10
9
12
- (05 - 79) -
1 START/STOP button
Pressed to start and stop operation.
2 LED lamp
Lights during operation.
3 Set temperature button
Selects the setting temperature.(18-30°C[COOL], 10-30°C[HEAT])
4 Fan control button
Selects the fan speed
5 Louver button
Set the airflow direction.
6 Room temperature sensor(inside)
7 Operating mode indicator
8 Set temperature
Indicates Indoor unit address. *4
9 Fan speed indicator
10 Airflow direction indicator
11 Status icons
Mode mismatch
Filter sign *5
Defrost operation
Oil recovery operation
Under maintenance
Error
Special state
Conducting electricity
Emergency stop
Operation controlled
Forced stop
Remote controller sensor is enabled *5
Central controlled
Setting temperature range is enabled
Operation prohibited
12 Indicates the remote controller address. *4
(AUTO * 1, COOL , DRY
*3) .
FAN *2, HEAT
(AUTO , HIGH , MED , LOW
QUIET ).
,
,